how can I fix hotpoint aquarius ultima 9567 microprofile 1400?

door cannot be open after a wash.

George
March 2010

I had an error code 31. However I could hear the motor running at normal speed, but the drum was not turning. When I took the machine apart the belt had come off because the bracket that sets the belt tension had broken. A replacement cost less than £10.00, though you could probably make something from some plate.

Dave
March 2009

E30 is a motor fault and E31 is a tacho fault. the tacho is the small magnet on the rear of the motor which has a coil around it and it sends out information to the control board to let it know if the drum is out of balance or not. If the magnet in the center of the Tacho has come off or the wiring to it has shorted out, the motor will instantly go into full spin, if the magnet has come off you will be looking for a slate grey disc about the size of a 1£ coin with a hole in the center,a small washer and a screw,these may now be under the machine. Also Check the motor brushes for excess wear (if either of the two brushes are pitted and sooty they both need replacing)

casper/www.selfixuk.com
April 2006