the back HALF comes off.lid off.remove 4x 8mm nut headed screws that hold back panel to the frame (silver arm bit at top).2 more screws at the very bottom corners of the back panel.in the middle of both sides is a plastic cap with a small hole in the centre.prise these caps out and then remove the 8mm screws from inside hole.unclip water pipe mounting and then slide the WHOLE back half away from the front.fit in reverse.YOU CAN put the belt on by pushing your arms down the back and fitting the belt over the motor pulley and then winding it on using the pulley wheel but it does hurt your arms and hands.lol
ck
December 2009
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix washing machines.