How can I fix my Hotpoint CTD40?

on/off button flashing now dryer keeps stopping

tony jones
August 2014

It seems a bit "viloent", but all you do is give the front edge of the top panel a good smack with the palm of your hand... the top panel slides backwards about 2 inches, and then just lifts off...
If it's just not getting hot : there are two overheat sensors in the back, just above the heater elements. They are about the size of a 10p piece, held in by two screws, two wires going to each. In the middle of each is a little hole. If you push the end of a paper clip into the hole you will hear a click as the one that has tripped resets. They are more likely to trip if you have the drier pushed hard back against a wall with no room behind it for air to circulate... hope this helps !

J.R.Copley
July 2009

SHOULD JUST PULL BACK TOWARDS YOU IF YOU ARE STANDING AT REAR OF DRYER. MAY HAVE TO WIGGLE IT A BIT COULD BE CLOGGED UP A LITTLE

FARBREW
June 2009