I have just installed a sy700 in a nissan pulsar but after I put in the code (wrong at first) but now I can't clear the "err" on the screen to put the right code in. How do I clear it so I can start again. Thanks in advance.
Hi how do you remove the stereo? I have one that was already installed but can't get it out
Amy
May 2015
Apparently if it contains a zero you press the relevant number ten times. Can someone confirm this?
George
February 2013
Just like to ask you what code you use, cos I have same problem thank you
Isan
August 2012
After reading the manual over and over, it finally clicked, you must leave the key on the accessories position and the radio switched on so thet "ERR" is displaying. Leave it on like this for an hour after which time it will reset back to "CODE" then enter your code again.
Remember with the code it is entered as follows:
Using the 1 2 3 4 memory keys with your code you MUST enter as follows, if code is 3241, this means
Hit the 1 Memory 3 times then a '3' will display
Hit the 2 Memory 2 times then a '2' will display
Hit the 3 Memory 4 times then a '4' will display
Hit the 4 Memory 1 time then a '1' will display
Activating the radio
Tony V
May 2009
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix in-car audio.