Mend > Home Heating Systems

water is too hot?

my hot water is too hot.i have fitted a new cylinder stat and set it at 50 deg but the water is still too hot, the boiler is an ideal classic and was set at 77 deg(no5) but i have reduced it to 72deg(no4) .

mick kitcher
April 2009

Heating, Home Heating Systems Water Too Hot

Have you considered trying setting number 3?

It could solve your problem and save you money :)

Peccavi
April 2009

check immersion isnt switched also zone valve could be stuck open so its always heating the cylinder.

aa
April 2009

Hi,

Where did you mount the stat on the immersion? it should be 1/3 from the bottom. Is it wired the right way?

IrishFire
April 2009

Find out how to mend home heating systems

British Gas 532/i Gas Combi Boiler?

Vaillant ecotec 831 plus?

How do I work my Storad storage heater?

Advice?

Fan tries to run every 15 seconds then stops immediately?

Worcester Bosch 532/i Combi Boiler?

Siemens RDJ10RF thermostat problem?

Vaillant F22 fault?

Boiler cycle?

Greenstar 25 combo boiler?

Worcester boiler dripping water?

Remove boiler cover?

Mend Home Heating Systems

Related Categories

Mend > Home Heating Systems

water is too hot?

water is too hot?

I can answer this question ...

water is too hot?

How to mend ...

Mend home heating systems ...

Worcester boiler dripping water?

Vaillant ecotec 831 plus?

Remove boiler cover?

Siemens RDJ10RF thermostat problem?

Boiler cycle?