worked fine one day and then the next it wouldnt,was told it was the thermocoupler but it doesnt have one,theres electricity and gas going to it and lights turn on but theres no clicking to ignite the pilot light to start it up!
any suggestions??
Had similar problem. Dousing the fan motor with WD40 did the trick - careful it's flammable! But looks like the motor is on it's way - and £130 to replace.
Mike W
November 2009
The hot water works ok but the central heating not working the control sytems indicates that it should be running but fails to ignite the wall thermostat when tested is opening and closeing
Mr Rob Heald
November 2007
Sounds like the selonoid for the flame rectification
barry myers
November 2006
hello mate,check to see if the fan is seized at the top where the flue is,BE SURE TO TURN OFF THE ELECTRICS FIRST!!
I had the same problem,and found that the bottom bearing of the motor was stiff/seizing.I managed to free it off,and go it to spin freely by hand,switched the elecs back on and it fired up!!
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home heating systems.