how do you change drum bearings on a zanussi zwf1211w?

it is not possible to remove drum from back of zanussi electrolux zwf1211w

mickey
March 2012

change bearings without expensive tools, you have to

1.open top.
2.remove rear of case.
3. disconnect all wiring and pipes to the drum.
4. remove pins on shocks on bottom.
5. remove spring on door seal.
6. seperate door seal from the outer case.
7. remove the clips on the jet system located at over the inside of door seal.
8. remove drum from rear of machine.
9. remove motor and belt wheel.
10. undo all screws around drum.
11.spilit drum and push out axle (may be tuff if its gone a while).
12. Hammer out bearings.
13. hammer in new bearings with old bearing over them to take the blow.
14. then put back together in reverse order.

Ps. its a dirty Job

Foxy
January 2009