Zanussi Turbodry 1200 with E10 code?

E10 can sometime occur on Zanussi Washer/Dryers if the outlet is blocked, check your outlet trap and the little pipe/channel that feeds in to it from the left - mine gets blocked occasionally and causes this error. Clean it out and it may save you changing a perfectly OK triple valve.

DB
October 2009

HAD THE SAME E10 PROBLEM,WITH THE ADVICE OF FROM RIC APRIL 2004 .CHECKED AND CHANGED THE TRIPLE INLET VALVE, NOW ALL OK. PART NUMBER 1249472117 FROM SERVICE FORCE AT HAYWARDS HEATH(01444417655) PRICE £19.59, COLLECTED

RICHARD STEERS
December 2005

If E10 is only appearing when trying to dry, the problem almost certainly is the condenser valve solenoid open circuit. The green solenoid on the inlet valve. Should read about 4000 ohms.

Ric
April 2005

I also have this problem - how did you guys fix it??

Mine did it a while back and after we moved it sorted itself out but it is now doing it again!

Any help would be gratefully received. Washer Dryer is now just out of warranty…. (Typical).

Any help would be greatfully recieved.

James Frost
April 2005

Hi Guys,

Mine has same problem. checked the reasons mentioned on Zanussi site but no good. How did you solve your problem?

Dipti
November 2004

Try this link - it suggests four possible problems and thus what might clear the error code.
http://www.zanussi-electrolux.co.uk/files/unitedkingdom_english/0-999/zanussi%20error%20codes.swf

Iain Macrae
November 2004

Marc, Mine has just started doing the same but I can't solve the problem either. If you've found the answer please please email me on d.w.cantwell@btopenworld.com

David Cantwell
October 2004