Just tighten them up, and recheck them after running a few hours, you should be ok.
Tony
January 2009
cheers tony for that can you advise on thread lock issue? I've just copper sliped them and tightened them up - i need to lock the shaft to fully tighten them I think.
ben
January 2009
yes you do - I removed the 4 bolts (16mm heads) and droped the yoke of the pulley.
Next question do you need to thread lock them when you reassemble?
ben
January 2009
Yes, the drive shaft go's to oil pump, so remove shaft, fit new belt, you may has I have done in the past leave a new one there for the next time.
howtomendit.com for free repair help, information and advice.
