DOORSEAL?

Undo the fixing (spring, twisted wire or plastic locking band) which attaches the seal to the outside shell and detach doorseal from outer machine shell. Power off, Remove the machine top, push drum towards the rear of machine and look down to where the doorseal attaches to the drum - you should seen another clamping band. Unscrew or otherwise remove this inner drum clamping band break it if necessary. If the clamp cannot be reused, go to an electrical store such as Maplin or similar and buy the longest cable clips available. Two or more clips can be connected together to form one long clip which can go round the inner part of the doorseal to hold it in place on the drum lip. Pull the doorseal away. Fitting the new seal is a bit like fitting a bicycle tyre on a new rim but on a bigger scale. Start at the bottom and work your way evenly up both sides, using levers if necessary. Lever the seal over the top rim. Ensure it is located correctly and refit both outer and inner clamping devices. If seal is obstructed by concrete weights the front panel and the concrete weight will have to be removed before seal can be detached.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy
November 2008