remove lid undo all outer screws on back plate , leave the screws fitted to heater back plate and bearing centre. make a note of wires to backplate and remove, you can now pull the whole back plate and drum back an inch, lower belt over the front of drum refit wires and back plate.Remove plastic cover rear bottom right hand side to fit belt over motor (springed pull over to the right hand side to fit belt over motor spindel and pulley wheel) turn drum by hand to check belt runs around motor pulley wheel and drum correctly
asuds-appliance-spares (ebay)
November 2008
howtomendit.com for free repair help, information and advice.
