Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre probably worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option. Check all wires and connectors generally for internal breakages - caused by movement of the wiring loom attached to the drum. Over a long period of time the wire strands inside the insulator break through metal fatigue. Although the outside of the wire appears ok the internal is open circuit. Pull on each individual wire - if theyre ok internally, they shouldnt stretch.
Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html
dannyboy
November 2008
howtomendit.com for free repair help, information and advice.
