how can I fix my Hunter Douglas honeycomb shades ?

Can I turn the honeycomb shades around to the other side. I bought a home with the shades in the but they are the wrong color for me. But the back side is a white color which would work. Is that possible?

Lori Hernandez
September 2014

hi i have honeycomb hunter douglas shades and they will not go back up. they do not have a string

msw
September 2013

Thank you, mrteem! I used this technique on a Bali shade. Repair was easy. Saved me from buying a new shade.

Gail
September 2010

cord to lower and raise the honeycomb blinds broke

rita
April 2010

cord to lower and raise the honeycomb blinds broke

rita
April 2010

The problem you are with the blinds going up unevenly is that the one or more of the pull up strings on the side going up first has tangled itself around the take up rod/spool and is therefore shorter than the other strings. The side that goes up first may also NOT go down all the way either. If you dig into and straighten out the tangles at the top (take up rod/spool) all the strings will be back to their factory set length and should work like new. Shortening the strings on the side that goes up last (as suggested) will only change your problem to one where neither side of the blind will go down all the way because the support strings are now all too short. (but I must admit both sides will indeed be even with that short sighted fix, at least till another tangle happens or is undone) You can practically eliminate tangling by religiously using the same side of the cord loop to pull-up and the opposite side of the cord loop to lower the blind. That way they wont have the opportunity to get tangled. This is a very common problem I think Hunter Douglas should have corrected with a physical pull-up/lower directional restricter of some sort years ago. (been there - done that - feel your pain - mrteem)

mrteem
September 2008

On the bottom rail where each string comes out, there is a small disk that you can pry away from the rail with your fingernail. Then just pull that string to even that side with the other one and push the disk back in.

Steph
September 2008