How do I bleed a clutch on a ford transit 2000 front wheel drive?

there is no bleed nipple on cylinder at gearbox end so how do you bleed system

tony
September 2009

you will need to remove clip that holds hose into slave cyl, pull out hose about 1/4" attach hose to plastic nipple [to catch lost fluid ],then get someone to operate pedal until air clears,push pipe in and refit clip.

k
August 2008

hi i've always found the easiest way is to fill up the brake fluid resevoir which supplies the clutch master cylinder. then open the bleed nipple and let it run out 4 a couple of minutes. the other way is to back bleed it with an oil can. if you do it this way make sure there is no oil left in can fill it with brake fluid attach it to the bleed nipple with a piece of pipe and pump it till you have no air at the resevoir

ash
August 2008