indesit d41 dishwasher?

fantastic - same problem, turned it on its side, mopped up water and away it went - cheers guys

Em
January 2014

Also had this problem, my anti-flood switch wasn't 'resetting'.
When the base fills with water the anti-flood switch will close the water intake valve.
When you tilt the dishwasher to empty and the anti-flood switch doesn't reset then the 1st light fault will start.
Put the machine on its side unscrew the 4x screws from the base plate.
Here you will find the anti-flood switch with the polystyrene float, just check it 'switches' correctly and put back together.
This worked for me on a 10 year old Indesit D41, try this before buying a new inlet valve.

Craig
June 2012

my dish washer won't start any cycle on all programs. it beeps and the pump starts to drain the water but it doesn't wash and the washing cycle led flashes on/off ?

Ben
August 2011

how do i get to water pump

jcox
May 2010

My D41 flooded the kitchen then stopped working, it then wouldn't stop trying to drain the water even when empty. I pulled it out, tipped it back and drained out lots more water. Its working again so far. I think it was the washing machine and dishwasher draining the same time and the drainpipe partly blocked so flooding back inside the machine.

Rob K
February 2010

Pulled dishwasher out and tipped it backwards, lots of brackish water came out the back, machine now works but perhaps it needs a new seal!

Alan S
January 2010

push the on button light comes on but nothig happens?

Chris Peberdy
July 2009

My Indesit D41 dishwasher beeps the first light comes on then goes out then the second light flashes with nothing else happening. Please help

Stuby
May 2009

Yes, ours was flooded base. I got the water out, then it did it again.

I had a further look and discovered that the salt reservoir had become loose and this was then leaking into the base. Tightened up the salt reservoir to make the seal tighter and hopefully that's it!! Last time I filled the salt up the whole thing moved so that must have been it.

Allan
February 2009

Unscrew the base panel from the bottom of the machine. Attached to this is a safety cut-off switch connected to a polystyrene float. Clear all water and debris from this, re-connect base panel and your problem will be solved

Jim D
May 2008

there is a switch under the machine, we had to reset ours

Kate
September 2004

Mine did similar. Flashed lights 2 & 3 together. I checked it out and found the water inlet solenoid had a wire loose! Popped it back on and away it went.

Fixed it!
August 2004