SOLUTION : Replacing heater on Hotpoint wt960?

I've had issues with the electrics tripping out and have had it repaired twice. The last repairer told me what the problem was and so when it happened again I fixed it myself.

The problem is caused by scaling. The element gets full of limescale and so trips out.

To replace the heater element first unplug the electrics!!!!

Remove the panel at the back (bottom) of the machine - 2 screws, on on the left and one on the top right of the panel.

You should see the motor on the left and to the right the electrics onto the heater element (see pic)

disconnect the spade fittings.

remove the sensor (carfully - it pulls out but for obvious reasons is a tight fit) - see pic

the element pulls out (see pic) but again it is very tight

replacement is the reverse.

The part no is 1604486 and the cheapest place I found for a replacement is

http://www.hotpointspares2u.co.uk/heating-element-1604486-p-37.html



Hope this helps someone - usual disclaimers apply i.e. you are advised to consult an eletrician, no liability accepted etc. etc.