Good news! I found this while desperately searching for the reason my Sharp CD-BA2650 suddenly said "protect":
For some reason your receiver is detecting a very low impedance (probably less than 4 ohms) on 1 or more of the speaker outputs, and is going into "protect" mode to protect itself against damage. If you are certain that your speaker wiring is good end-to-end, then maybe one of your speakers is causing the problem. You can try disconnecting all the speakers, then attach one speaker at a time, turning up the volume to see which one is causing the problem.
This suggests a speaker or wire. I will replace my wire, and test the speakers with another unit. Cup your hand over the speaker (for small ones) and then move it away. If the sounds changes, the speaker may be bad.
zizzergirl
October 2005