vaillant turbomax vuw 242/1e ignition problem?

You should switch off vaillant, open it, open steel plate and disconnect blue pipe for a while ...
Sometimes there is drop of water in it or dirtiness.
If you don't want to do it - you can try to fix it by hitting a round device at the top of vaillant (visible from above) + there are two pipes connected to this. The blue one is responsible for the problem.

arkad
December 2009

Its a big shit I have the same problem and tink to rip of the vaillant of the wall. Vaillant never again.
I will take a Junkers hopely its better.
Vaillant came to us and change each time parts.
Vaillant service is not abel to salve the problem !!!

michel
October 2009

Did your engineer replace the electrodes / flame rectification sensor? If not they should be replaced or at the very least cleaned and re-set to the correct gap (4mm/ width of a pound coin)

It sounds like the flame rectification cannot recognise the flame picture and shuts down the burner, it then tries automatically to light the burner 3 or 5 times (depending on which pcb you have) then goes to lockout.

Richard (ex Vaillant engineer)
August 2009

no,not a single answer.my service engineer advised me to contact valliant directly,but all they seem to want is for me to take a service contract out with them.

john y
January 2009

i am also having a similar problem did u get an answer atall? thanks

Chris
October 2008