Recent: Safely remove screen protector from a Macbook Air?

Mend > Washing Machines

Mend Kenmore 90 series Series Filling

My Kenmore 90 series washer is filling sooooooo slowly--HELP!?

My washer is taking forever to fill--it takes about 30 minutes for a full load to fill, then another 30 for the rinse cycle. My laundry is piling up so high that I fear for my safety!! I have used different settings (cold, warm, hot) and warm seems to sound like the most water, but it is still just a trickle from either side of the water inlet into the washer. Thanks in advance for your help.

Stevie Sturla
April 2008
I have checked my supply lines (hot and cold) and they are fine. I cleaned the screen at the back of the washer and it is fine. What do I do next? There must be a clog in the line inside of the machine for both the hot and cold water.

Any suggestions?

JD's Kenmore Series 90 Washer Water supply problem.
September 2008
turn off both taps that supply the water to the machine, remove cold pipe and place into a bucket turn on turn you should have a good supply (not a dribble )if a dribble check HOW PIPE IS CONNECTED TO YOUR SUPPLY repeat this test for the other tap.
Do you have self cutting taps fitted ? you can tell these as they clamp onto the supply check supply hole for blockage of rust better still CHANGE TAPS, ( washer WILL struggles to fill through a LITTLE HOLE 1/8" BIG )now look in the rear of machine where the taps attach you will see plastic mesh FILTERS remove and clean lime scale etc replace and try FILLING machine again

wirecutterman
April 2008

Automatic Answer

We may have found other answers which could help you.

Click here for Kenmore Series Filling

Related Questions ...

Mend washing machine kenmore cold water
1

Kenmore 80 series model - high pitch sound while filling?

Kenmore 80 series model 110.28803890 makes high pitch sound when cold water filling.
Mend water wont stop filling
1

water wont stop filling ?

kenmore 90 series start washing cycle, water level was set on low and yet it kept filling way beyond its point... [Read more]
Mend water filling tub
1

water filling the tub?

When I turn on the water for my Kenmore 90 series it starts filling with water even if the cycle knob is in th... [Read more]
Mend washer keeps filling
1

Washer keeps filling and overflows?

My Kenmore Series 80 washer keeps filling no matter what water level I have selected. It continues filling un... [Read more]
Mend kenmore washing machine 80 series rinse cycle
1

How can I fix Kenmore 80 Series Washing Machine Model 110.26842690?

I have a Kenmore 80 Series Washing Machine, Model No. 110.2682690, Serial No CG 1320283. When I put the wash o... [Read more]
Mend washing machine agitate water level
3

Kenmore Ultra Fabric Care II 90 won't stop filling?

I just installed my washing machine after a move and discovered that it will not stop filling therefore it won... [Read more]
Mend kenmore 60 series washer
1

How can I fix my Kenmore 60 Series washer?

My Kenmore 60 Series Heavy Duty washer is leaking, (not from any hose connections) as soon as I turn it on & i... [Read more]
Mend washing machine repair agitator
2

kenmore elite series 80 washing machine?

My washing machine agitator stopped spinning and actually spins freely (by hand). Machine appears to go throu... [Read more]
Mend series kenmore model 110 serial
1

WHAT COULD BE WRONG...WATER NOT FILLING TO CORRECT LEVEL?

I HAVE A 70 SERIES KENMORE MODEL 110 SERIAL #CF4701060 AND THE WATER WILL NOT FILL PROPERLY ANYMORE. IT ONLY ... [Read more]
Mend washing machine draining kenmore
1

Why Washing machine draining while filling?

Have just bought used Kenmore 80 series heavy duty model 110 I just wanted to test it in garage as i have to t... [Read more]
Mend washer sensor repair
1

Kenmore 70 Series: water doesnt stop filling, just drains out?

I have a Kenmore 70 series washer. Everything works great except when it is filling with water, it doesnt eve... [Read more]
Mend washer repair leak
1

leaking - Kenmore 90 series washer?

Very front on the bottom of the washer ... looks like a motor turning during filling ... small leak coming fro... [Read more]
Mend kenmore 90 series washer
2

kenmore 90 series washer?

Have a kenmore 90 series model washer model # 110-23812100. The lid switch broke on it but before I could get ... [Read more]
Mend washer series model
2

Washer wont recognize how full it is when filling with water?

My washer (Kenmore 80 Series - model no: 110.27822790) does not recognize how much water is being pumped into ... [Read more]
Mend kenmore series 70 water cycle
1

kenmore series 70 washer water fill will not stop filling up?

kenmore series 70 washer overflows during the fill cycle. and it will not stop filling at the rinse cycle eith... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Washing Machines ...