Non-working Minivator 1000?My minivator 1000 was just reinstalled in my new condo. After fixing a few problems that were quite obvious and replacing the batteries, power up shows the - in the diag window but it doesn't move. looking at the pcb I see the LED is flashing red. It mentions the OSB in the Fault Analysis chart as b...Click here for the fix.
Bison Bede 50 reset after battery change?Bison 50 - batteries 100% discharged - replaced 33v charger and batteries now 100 % - How do I initiate a reset to release the brake on the motor? I was told this is a safety feature when the batteries are totally drained.
Thanks,...Click here for how to mend it.
Stannah 260 stopping after couple of metres ... help!?My Stannah 260 was installed by Stannah through our local Council with Disabled Facilities Grant. This week it has begun halting after couple of metres .. if I turn off at arm, it will move a short way then stop again. What is wrong please?
Stannah quote far too much for us to pay so I cannot use ...Click here for the fix.
How to reset a Bison Classic stairlift. Installation fault flashing "E"?How to reset a Bison Classic stairlift. Installation fault flashing "E"...Click here for the repair.
during going up the stairs the chair only travels at half speed?during going up the stairs the chair only travels at half speed why...Click here for the fix.
Removing batteries on stannah 420 stairlift ?I have tried replacing a pair of batteries on a stannah 420 stairlift,I can remove the lower battery but not the top battery because the seat is too low down and I can’t remove the cover, any ideas of how to raise the seat?...Click here for the fix.
Stannah 300?Im looking for a local engineer Cw12 Congleton to have a look and serivice a Stannah 300 does anyone have a phone number for one
Many thanks...Click here for how to mend it.
where can I purchase Stanna 420, two carbon brush assembly?Where can I purchase Stanna 420, Carbon Brush Assembly in USA?...Click here for the repair.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.