Water leaking from drum input shaft down onto the base tripping the float switch and giving the fault code C3, how do I remove the pulley wheel that drives the drum it has a Allen screw in the centre is the thread clockwise or anticlockwise ( ie lefthand thread )
If you have water coming out of the drum shaft then the shaft seal inside the drum is faulty you wont reach it by just removing the pulley, you will need to split the tank and remove the drum. Anyway to answer your question i have only ever found the pulley retaining bolts to be right hand thread eg "normal type of thread". But the bolts are quite often coated with a Loctite solution to prevent them coming loose and can be B........ (difficult to remove)
How can I fix my AEG Lavamat Turbo 14710VIT?The main drum bearing is very noisy.
I can access it from the rear and have removed the drum wheel but then how can I get the bearing out? Is further dismantling required?
Thanks for any assistance...Click here for how to mend it.
The code ef0 appears in my Aeg machine ,what shoul i to to mend it . Thank ?How should i mend the efo code in aeg machine? Thank you in advance...Click here for how to mend it.
aeg lavamat 72620?I have error code C9 motor issue displayed on the LED front screen. I can reset this ok using the sequence of pressing the buttons, but, after 5 minutes, the error reappears. I have replaced the motor and also brushes, but exactly the same issue appears. The motor spins for 2 seconds and then gently...Click here for how to mend it.
aeg lavamat turbo 16810 error code e90?aeg lavamat turbo 16810 washing machine has error code e90,what does this refer to and how do I repair fault...Click here for how to mend it.
It is showing C3 what does this mean.?I have an AEG Oko Lavamat 88730 Update washing machine. It is displaying the code C3, the alarm is sounding and the pump continues to function. Can you tell me if this is repairable and is it an expensive repair....Click here for the repair.
How to I removel the front panel on a AEG 16830?I need to remove the front panel from my AEG washer/dryer as the little drain tube in the kick plate has come out too far & I now have water all over the floor. Does the panel unbolt from the top or do I have to lay the machine on its back?...Click here for the fix.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.