i am trying to restore a sims super v she needs a lot of T.L.C but number one on the list is a new windscreen but i can not find one can any one help .thanks
colin, December 2010
I need to do the same thing, I've been told to get a sheet of polycarbonate as it can be shaped without heat (unlike perspex) also for restoring the ends of the rubber I would get a tube of what's commonly known as panel fix/sika-flex/tiger seal. you can get it from most good auto spares shops. once you have applied it. use a wet finger to mould it in place hope this helps.
My Boat has an inboard engine, it runs Good but The propeller does not spin?My Boat has a v8 engine that works great but The propeller spins but if i hold it with my hands stops spinning i guess a gear Or a shaft is stripped Or broken. What to do to fix it?...Click here for the repair.
how to free a zipper to work that has sea salt on it.?I have a bag with equipment in side it - that got wet with sea salt and it has a zipper that I cannot unzip. It has been setting for a couple of years. I have tried marvel oil and hot water. That does not work. What can I use to free the zipper??????...Click here for the fix.
how many coats of varnish should I apply to a clinker dinghy?I have an old clinker built dinghy built in the 1930s. This has been out of the water for 3 years and I have recently rubbed it down and re varnished and antifouled it.
How many of layers of varnish would anyone recommend?...Click here for the repair.
Whats the best way to replace drainage bungs on a wooden dinghy? ?Please help me with my old but newly acquired wooden sailing dinghy which has two drainage bungs in the transom, one of which doesn't tighten anymore and lets in water. Whats the best way to replace and what should I bed the bung holder into ? Is this an easy job for a new boat owner and beginner bo...Click here for how to mend it.
Please help a DIY beginner fix a small leak in GP14 dinghy ? ?I'm a novice restoring an old GP14 wooden dinghy, it is in good condition generally but is leaking water through the seam where the first panel of marine plywood from the top then joins the piece that slants down towards the underneath of the boat. I have narrowed it down to somewhere at the front b...Click here for the fix.
how to repair a small hole in mirror hull?I am new to sailing and was given a mirror sailing boat.
I am going to have ago of restoring it, its not that bad concisdering its 40 yrs old.
When fetched it on the trailer, theres a roller on the trailer that went through the bottom of the hull and havn't a clue to fix it.
I would be very much ...Click here for how to mend it.
repairs can be dangerous.
In many instances work should only be undertaken by a qualified
professional. Ensure you have read our Small
Print page before using information supplied via this website.