I have the ADP8322 integrated dishwasher, typically its now out of guarantee and last night about 10 minutes into a wash cycle it stopped washing and started continuous beeping, when i opended the door the Pre-rinse light stays on and the start button flashes continuously.
This morning i have cleaned out the filter, topped up the rinse aid and salt and switched it off for a while by the mains, i have just tried again and it started to wash for about 30 seconds then beeping started again with exactly the same flashing start button and wash programme back onto pre-rinse. I was wondering if you have any suggestions as to what i could try to get it to work.
my diplomat ADP8322 has bleeps and flashes 11 times???
Haydn
April 2016
check how many times the start light flashs, this means different error codes.
the most common are flash 3 times pause then flash 3 times again: fault heating problem which means its a fault with the heater, ntc sensor or main pcb.
second fault is flashs 4 times pause flashs four times again: fault draining problem which means it could be a faulting pump and blocked pump or check if its going into a sink check the conection at the end of the pipe is not blocked.
but let me tell you if its the flashs 3 times one and you have ta pay for the repair i wouldn't bother it gonna cost ya about £120 ta get fixed and thats if its not the pcb, if its the pcb thats gone the pcb boards alone are £139 inc vat!
bradley Stocker (white goods enginer)
June 2010
hI i HAVE THE SAME PROBLEM AS CHARLANE MY DIPLOMAT DISHWASHER KEEPS GOING TO THE PRE WASH CYCLE AND THEN BEEPIN AND LIGHTS FLASHING JUST DO NOT KNOW WHAT TO DO ITS A INTERGRAL AS WELL HELP
ELA
July 2009
My ADP8322 dishwasher kept bleeping and the soap dispenser would not open. To solve the problem you have to clean the black filter at the bottom of the diskwasher it gets very clogged up. To access the filter you have to uplug and remove the diskwasher and turn it on its side. then form the bottom up can see the black fillter you have to turn and lift the clip to remove the filter assembly.
darren
November 2008
mine is only 6 months old must be usual thing with this dishwasher. shouldnt be allowed. what was the outcome on yours. regards
gaby
September 2008
The amount of times the start light flashes relates to a fault code,hold down start button for 5 sec to reset and try again on chosen program.Good luck.
JAYBEE
December 2007
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix dishwashers.