If you are using well water have the water tested. You may need to condition the water to avoid additional leaks. Pin holes indicate thinning of the pipe wall throughout the system.
John
July 2007
>pushfit connector
as stated fit a new section of copper pipe
pushfit - don't want no d.i.y bodges where they can't be seen
and are known to blow off later on.
hi-spec plumbing
July 2007
hi all u need is a straight pushfit connector 15" depending on pipe size....cut the pipe where the hole is and put the connector on one side and push the other side of the pipe in...easy.
sid
July 2007
You can buy a repairing clamp,similar to the clamp on washing machine tap, but without the tap, but as "t" said, best to replace the piece of pipe if you can !
Pete
July 2007
Solder over the hole
Billy
July 2007
A pin hole usually means corrosion and so it would be best to replace the whole pipe. However one can get kits for taping them up from DIY stores.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix plumbing.