Tape stuck in a Panasonic PV-8450?

I did what Lora on July 2005 said to do to unstick a vcr tape in a PV 8450. It WORKS! I came right out on it's own. THANKS

Chip T.
August 2009

I have a little bit of info that might be helpful to someone out there.

I have a Magnavox/Philips 90's vcr and there was a tape in it that would not eject. It would not do anything. When I turned it on it would make a sound like it was starting up (whirring sound) then it would just turn off. I read lots of sites to see what to do and found one that told how to manually eject the tape. I was looking around in the VCR to see if I could find the worm drive the site was talking about. I noticed there was a belt drive that seemed to be running things so I tried to turn it. When the vcr was on the motor and belt would turn feely but when it was off it wouldn't turn. I unplugged the vcr and tried to turn it (just a little turn towards the front of the vcr by putting my finger on top of the pully and rolling towards the front) and it turned and made a little click noise down where the belt was attached below so I plugged it in again and the tape ejected! It works fine now.

Short version: Try unplugging the vcr and turning the belt drive a little (both ways) and plug it in again and see if it works.

Hope this helps someone.

Lora
July 2005

i have the same problem..

Marie
March 2005