Mend Gainsborough Baths and Showers

Mend Bathroom Appliances, Baths and Showers

Find out how to mend it for free.

Ask Question

Click here to mend Gainsborough baths and showers

Mend baths and showers ...

Mend Baths and Showers

Mend > Baths and Showers

Mend Gainsborough Electric Button Switch

How do I mend an electric shower that won't turn off?

I have a gainsborough electric shower with a button to switch the water on and off. The shower has regularly not stopped when I press the button. Today resorted to turning the water off at the stopcock. Eventually stopped after 30 minutes of pressing the button on and off.

Do I need a new shower?

Anna
March 2007

Gainsborough Bathroom Appliances, Baths and Showers Electric Button Switch

Had the same problem, fitted the shower and worked for the first few times, then had intermittent problems with the button not releasing when trying to turn it off.

Took the cover off and refitted the cable and pipework plastic cover (bottom right corner) and ensured that cable supply wasn't pressing against the cover causing it to distort.

Works fine now, but I have to say it's not the best design in the world.

Russell Rees
November 2022

I've just tried to fix this using the 3 washers but it didn't make any difference. In the end I noticed the small spring/pin in the top right by the electric was pressing against one of the plastic guards protecting the wiring. I just free'd up a little space here so the spring/pin can move freely, works a treat now. All in all another day off from work fixing things around the house, typical!

Lee
February 2010

My tenant just rang me now with the same problem. Invest in some pliers and pull the button out as hard as you can. This should fix the problem. Remmeber to turn teh electric off before doing it or you might just electify yourself.
www.rightsolicitor.com

james
October 2009

these showers are cr*p had 3 new ones in the last 4yrs with same fault do what i do each time go to ur local stockist and by the same shower remove the new inner workings and replace with old broken shower then take it back to store sorted

bb
July 2009

Hi. This shower has been designed by a monkey for sure!
You'll find three small plastic "washers" taped to the inside of the cover. You need to use these washers to space the main body of the shower away from the wall when fitting.
If you don't use them and fit directly to the wall you will experience the problems with the water shut off button.
Why they couldn't design the thing with the spacers in place already i'll never know.

Good luck.

Michael Fielding
April 2008

Phone the help desk and they will talk you through fitting a new button and/or checking the cover is fitted well. The cover is critical and check it for damage or distortion due to electrical cable pushing against it. Can try pressing against the righthand side of the cover near the button to see if that helps. Remember the unit is meant to run on for 5 seconds anyway.

someonewhoknows
September 2007

The start stop button is out of allignment. Its a sh*t design.
Could also be the spring behind the start stop button.

jazzy
August 2007

You should have a pullcord switch to the shower with a light showing that it is on,power to the shower always goes through a pullcord,have it looked at it sounds dangerous.

Anon
March 2007