Remove No.1 injector and put a piece of wire carefully down the hole. When the wire is fully raised the piston is at Top Dead Centre. The hole in the flywheel should now be level with the opening for the crank angle sensor for you to put the correct locking pin in. You may want to lift your rocker cover and check your push rods. They are probably bent.
Stuart@walz diesel
March 2007
As James says, but if the van is Turbo the engine speed sensor will be in the hole and will need removing first.
MrMPuk
March 2007
no need to remove the starter as theres a hole just above starter but below the fuel filter, with the radiator removed you should be able to see it kneeling at the front
james
March 2007
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix vans.