E4 Error on Baumatic BDW13 Dishwasher?

We did exactly what Simon said instructed and it took about 10mins to fix just completed the first cycle
Many thanks Mark

mark
October 2012

E4 Fix from Simon, tobyhost worked a treat. thanks. No need to unscrew the whole plate though, as we had two black plastic access panels.

Ellie
October 2010

tilted the dishwasher, water flowed out and then worked again.

brilliant idea!!

Thanks

jay79
September 2010

my diswasher keeps triping the RCD half way through a cycle.

Liz
October 2009

Error 4 means that there is water underneath (usually from an "overfill") IF!! you dishwasher is out of warranty, underneath the door is a plate (as wide as the dishwasher) ind about 6inches high. Remove the screws and the kick board retainers, rear feet screws and prise off the plate, you should now see a float trip mechenisim, "!!!!switch off the dishwasher!!!!!" and using a sponge soak up the water, using something "Non conductive," trigger the switch a couple of times then restart the dishwasher."

The switch is triggered by a polystyrene float, water in the bottom will lift the float and trigger a drain cycle. Please also remember to check the sink hole in the inside of the dishwasher as food build up will adjust the water level, and send water down the overflow pipes. also note that water that has collected at the back of the dishwasher will move forward as the cycle vibrates the machine so may cause it again.

hope this helps all

Simon
Tobyhost.co.uk

tobyhost.co.uk
August 2007

Same as me,,,, same fault

vernon
July 2007

No I have the same fault, will try and tilt the machine like you have.

Dave
March 2007