Hello
Whilst successfully repositioning an existing PIR, I have accidentally set another PIR in my home as a fire sensor, so regardless of whether the alarm is set or not, that PIR sounds the alarm if it detects movement.
I know the engineer code. The alarm is a Scantronic 9800 series.
I really hope you can help as I currently can't use my alarm. I have it in Engineer mode at the moment.
Many thanks in anticipation
I must seeing things? it looks the OP has replied back that is very rare.
j
October 2016
no prob and thank you for the reply
gts
September 2016
gts. Job done. Phew. Many thanks
Joe Alessi
September 2016
g0 to the engineering section key in the zone 08 then key in 03 then press 99 enter the panel will load the zone to a1 normal alarm that will sort u out
gts
September 2016
gts. I'm not a troll, I have better things to do than troll howtomendit.com or anybody else for that matter. And I did do it accidentally by inadvertently keying my code into the keypad when exiting engineers mode instead of 99. So zone 8 PIR is now a fire sensor. All I'd like to know is how to reset it back to normal
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.