Creda Oven (48197) How do you Replace the Control Panel Bulb?

How do you Replace the fluorescent tube and the ring warning lights on a Creda Concept Cooker?

KEITH ADCOCK
March 2008

This requires some work. It's not as simple as you might think it would be. You have to remove both side panels from the cooker. These should be held by 3 small screws at the front(behind the oven doors) and another 3 at the rear. Then, the panels slide back approx 1 inch. From this position, they simply pull off. Once these are off, you need to remove the screws holding on the hob. There should be 2 at the rear, just below the spacer. These screw vertically. A further 2 screws hold the hob in place. These are located near to the front on both sides, only now exposed with the side panels removed. Remove these, then simply lift the hob up. Do not remove it completely, simply move it back a little and let it balance. You will now see a metal plate with 2 groups of wires going into it. It is held on with 4 screws, 2 on either side. Remove these and the bulb is attached to the rear of this metal plate. The bulb is a F13W/35 fluorescent. Hope this helps and isn't too confusing.

Digger
February 2005