Ford Mondeo 2.0 Ghia Central Locking doesn't operate?

Thanks for your help. Fixed it using the mirez.co.uk site, problem was the 5 orange cables under the driver's seat. Cleaned up, soldered and pooof, all in working order.

Cheers
Mark

Mark
November 2006

Infrared Programming Instructions:

Put your key into the ignition and turn to position 1 (Radio). After approximately 10 seconds the red alarm control LED (next to the clock) should illuminate. As soon as it comes on remove the key from the ignition - the LED should remain lit.
Point the remote's "eye" at one of the front door sensors and press the rear button until the light on the transmitter illuminates (Keep the button pressed)
With the rear button held in press the front button 4 times then release both at the same time. The control lights in both clock and fob will flash 4 times to indicate programming complete.
Turn the ignition back on to exit programming mode

any probs, contact me crapcarsrus@hotmail.com

dood
November 2006

http://www.mirez.co.uk/AlarmProbs.htm
follow the instructions, you shouldn't have a problem.

just in case you can't find the page from the above link

http://www.mirez.co.uk/KeyProg.htm

dood
November 2006

http://www.mirez.co.uk/AlarmProbs.htm
follow the instructions, you shouldn't have a problem.

dood
November 2006