How can I fix my scant tonic alarm 9651?

no prob dave,any time

gts
April 2013

That's great, will give that a go otherwise I'm going to change pcb. Really appreciate your time

Big Dave
April 2013

they make the 9651 in two versions the one i gave you is uk unit,but if you have done as you said,it sounds like it could be the pcb,but you could try one more thing,do a full reset on the panel,this some times works,as i said scanny panels are very reliable,we have used over a 1000 of them,and the 9651 is our stock panel
ob you will need to reprogramme it

gts
April 2013

Have applied 0v before

Big Dave
April 2013

Cheers, my hardware control unit installation guide has pcb layout on page 10 for 9651. Not on page 13. Anti tamp top left, on this diagram. Will link out com a/t and apply 0v on tr on bell at pcb. Have already tried this. Think pcb is problem

Big Dave
April 2013

do you understand what i mean ?on the pcb top ;left hand side 4 terminals down ,link to 0v there are two 0v it not matter what one you use

gts
April 2013

hope this helps mate

gts
April 2013

page 13 top right hand side,four terminals down, link to bottom terminal 0v

gts
April 2013

Thanks, appreciate that if you can send link

Big Dave
April 2013

do you have the engineering manual
?if so get back to me now

gts
April 2013

cant tell you that mate.look at the engineering manual its all there we cant tell people how to defeat a tamper of any type on an open forum,for obvious reasons

gts
April 2013

How do I link out the tamper at the pcb. I am an electrician and have never had this problem with a scantronic before. Really appreciate the advice

Big Dave
April 2013

lid tamp is because you have removed the lid of the case ,you need to check the tamper circuit to and from the bell box,if you are certain the wiring is ok,and the tamper switches are ok,and the bell box is ok,you could do as a1 says,but this is only a test of the pcb,you cant leave the bell box without tamper protection,as your insurance comp will tell you,the panel you have is very reliable,so my money is on either the wiring to the bell box,or,the bell box itself

gts
April 2013

link out the bell tamper directly at the pcb

A1
April 2013