scantroni 9500?

classic door contact fault,check it,or as e manno asked,check what ever is the final door sensor

gts
October 2012

Sorry op just realised it's the four branch with LIM's,

You really need an engineer in to run full diagnostics,it's an old panel but you should really have it on a maintenance contract.

Hope when you replaced the battery you powered back up with battery first then mains?

Seen both versions of the 9500 with blown pcb's because they haven't been booted battery first, plays a nice tune on LIM test, depending on software running though.

I suggest getting engineer in who knows this system, but stick around mate, you may get a more positive answer.

Good luck.

e manno
October 2012

When set,you are leaving by the correct exit route ?.

e manno
October 2012

So a walk test didn't reveal any open circuits?,

Check timers in engineering,

Did you have this issue before you replaced the battery and what type of sensor have you for final exit, eg PIR, door reed, or final set button.

e manno
October 2012