Phillips radiosat 6000 code needed?

Hi sid
did you check that Q063
if it's O063 code = 1912
you can send me a photo of the label if you like to
codehelp(at)hotmail.co.uk

hay88
May 2011

Thanks hay88,but 9916 does not work.i understand how to install them,just put old radio back in no problem,after holding the button it beeps,but a deeper tone then display just reads CODE.

sid
May 2011

sid
Q063 = code 9916 so please check that Q063
Also when entering code you must hold at the end to store the code for a few seconds.
You must hold at the end to store your code.
IF YOU DONT HAVE ¬ KEY THEN PUSH THUMBWHEEL IN AND SOME HAVE {A¬} KEY

Turn on the radio and the display will show 'CODE'
Use the steering controls for code entry.
Press the [ ¬] button then rotate the thumb wheel for the correct first digit
Press the [ ¬] button then rotate the thumb wheel for the correct second digit
Press the [ ¬] button then rotate the thumb wheel for the correct third digit
Press the [ ¬] button then rotate the thumb wheel for the correct fourth digit
If the correct code is now shown on screen,
press and hold the [ ¬] button for up to 10 seconds to store the code

FOR NO STEERING CONTROL
press the first preset button for the 1st digit,
second button for the 2nd digit
third button for 3rd digit
forth button for 4th digit
then press and HOLD button 6 to store. for 10 seconds

and on some it's hold 5 to store.

hay88
May 2011