I have a scantronic 9800 and the service and fault light is on. I have tried entering the engineer codes which is 7890 and then 99. But his just set the alarm off and the have to enter my 4 digit code to stop the alarm.
we gave this guy all the info he needs in a previous question he asked,
gts
December 2010
and what makes you think that he knows what boot up means mate?
gts
December 2010
You have not got the right alarm engineer code, if you cannot get hold of the installer you need to power down take out the nvm 8 pin chip boot up and put back in. all codes will default and zones reset and need programming back up.
Pete.
December 2010
welcome to the club nick.
gts
December 2010
Dario, why on eath do you think us engineers would leave a factory set code of 7890 in a panel. Ive had 3 calls today asking why when people enter this code does it not work. General Public read previous posts, Our answers are becomming less help-full because it gets rather BORING typing the same answers out over and over again.
Nick
December 2010
we gave this guy info before alarm guy,and for same prob
gts
December 2010
Firstly that is not how to enter engineering. Close but no dice.
Secondly you need a new standby battery.
Ever noticed if you did a search thats what 99% of the questions are on here................bet you never looked did you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.