reset code or engineer number re 9448+ style scantronic?

there are two molex pins on the pc to reset panel back to the default codes,but if you do this you will need to reprog the panel,they are marked rst.they are near the large micro chip,power down thje panel,mains and battery,place a blade of the screw driver across the pins,apply battery power,then mains,,,the system will now load the factory default codes,remove the screwdriver blade,key in 1234,close panel,key in 1234,then key in 0 enter,7890,you are now in engineering prog,when your finshed programming,key in 99 enter,

gts
November 2010

RST by the processor is where the pins be arrrrrrrrrrrrrrrrrr.
oops pirate impression got out.
But you may need to reprogramme.
Several companies in Middlesex ( and me) but this is no place for personal numbers or emails.

Try these instead, and no not me.
http://www.burglaralarmfinder.co.uk/city-Uxbridge/1845203-alarm-Intelligent-Security-And-Fire-Ltd.html

Alarm
November 2010