How Can I Fix My Mini Dirt Bike?

At the bottom of the carb is a small screw turn off the petrol and undo the screw wait until all of the petrol and 2 stroke is out put the screw back in and then turn the petrol back on,

Start the mini dirt bike and let it warm up for at least 1 min the see if it dose it if it still does that lift up the back with front on the ground and gie it a good rev if this gets better then the job is done if not buy a upgrade for the jet inside the carb

luke lawrence
July 2007

its all good taking the air filter off but then you suck in dirt and get a blocked carb.
upjet the carb!!

luke
June 2007

Tristian, have you checked that the fuel tank is clean? You may want to drain the tank and check for debris. Then follow the fuel line to its conclusion for any kinks or blockages. Good Luck

Jim Burton
July 2006

the problem is clearly lack of fuel,it stalls when you rev it beacause the extra air it gets when the slide lifts up is not what it wants,it needs more fuel too the needle the controls the speed the fuel is sucked in is joined to the slide that controls the air but it doesnt lift out much when first throttled only when the slide is right up.i would say the main jet needs to be bigger or you could try changing the position of the circlip on the needle in the throttle slide also the float level that alters the fuel level in the float bowl can cause this too but its unlikely this would change without you altering it .the problem is that the emission levels these bikes are produced to stick too are so low that all the settings on the carb will be set to make the bike run as lean as possible (using less fuel)taking of the air filter is the last thing it needs this will only cause the engine to get more air !i would first try movint the circlip on the throttle slide to the slot nearest the pointed end of the nedle if that doensnt work try a bigger main jet.if you cannot get a jet then increase the size of the hole in the jet to approx 10 bigger than it is i.e say it has a 100 main jet in it drill the hole to a 110 by using a 1.1mm drill bit ok let me know what happens mate,adam

adam bike doctor
July 2006

i have had this problem alot with my sons dirt bike the problem seems to be the air filter i used to clean it all the time but would not last long before the bike would loose speed then stall so i removed the filter altogether and now i dont have that problem it runs all day without loosing speed or stalling

johnny the boy
July 2006