how can I deactivate my scantronic 9450 alarm?

you use any "professional" sites ?

Alarm
September 2010

and i dont know if any of my guys are on line,i dont ask them,

gts
September 2010

to let you guys know the profile of my company,we have been in business for 37 years,we have a customer base of 2.800,and have forty seven engineers,we do all types of fire and burglar alarm systems,so please forgive me if i,or any of my engineers get a tiny bit annoyed with stupid questions,or come to that,people who ask for help and want to argue the toss,if you know better,go with it,my company pays my engineers email accounts.and i dont mind in the least,all my guys are first class,so,i f you dont want to take the advice they offer,so be it

gts
September 2010

have ordered a supply of duct tape and glue

gts
September 2010

so,thats how you fit 7 amp battery,i,ll keep it in mind,ta much :p

gts
September 2010

and to answer acorns question,why default panel,
we have on a few occasions had the 9450 and the later 9448 go into lock out,and the only way to restore it was to default,just like rebooting a comp,
and we do know the dif between user and egin instrucs,but ta for the tip:-)

gts
September 2010

7Ah easy.
Open lid do as described above. Get hacksaw and remove bottom part of front panel (Remember to keep the lug for the tamper spring). Push back together and then go out and buy the superglue and duct tape I forgot to mention and seal it all back up.

Sorted

:P

Alarm
September 2010

i was wondering how he was going to fit a 7 amp battery,:-)

gts
September 2010

try it acorns way,see how you get on

gts
September 2010

Whoops, wrong size battery, sorry, replace like for like.

acorn
September 2010

Oh dear, just open the control panel, with the 'mains on', you should get a tamper sound, enter your code to silence.

Remove the old battery & replace with a 7Amp.

Close the panel, enter your user code, once/twice, (can't remember), job done.

There is no reason to default the controls, you will have an even bigger problem if you do that.

Why default a perfectly good control panel.

By the way the User manual will be of NO USE to you to re-programme, that's what it is, a User Manual not the Installation & Programming Manual.

Do the above, get back again if you have further problems.

acorn
September 2010

the battery is faulty,if you open the panel,you will need engineering code to reset ,the default is 07890,if the alarm company who fitted the system has changed it,you will need to do a full reset,that will put it back to factory defaults,to do this,turn mains off,open cover,remove red lead from battery,locate two little pins on the printed circuit board,place a small screw driver between them,put red lead back on battery,remove screw driver,close panel,apply mains,the user code will now be 1234,the eng code will be 07890,you now have done a full reset,you can change the user code to what it was now.i take it that you have the user manual

gts
September 2010