I have a Scantronic 9200 that seems to have a problem. Usually it has a red light on, next to where it says 'day' on the case. However, now it has a green light next to 'power', and I can't set or unset the alarm, nor can I enter the engineer mode. Basically whatever I enter, nothing happens.
The circuit that it is wired on is working, and I have changed the fuse, with no joy. Any ideas what could be the problem?
I my alarm went off last night and zone 1 is showing in red. I've tried to re set the alrm, but can't. Can you tell me how I get the work back to normal please?
Barry
September 2019
i try and set the alarm but it lights up zone 2 all the time - i don't know how to clear it, as can't set the alarm properly
allison
August 2017
Flush key pad has warning red light flashing entered engineers code plus 99 exit but panel is dead apart from green on and red flashing
John
April 2017
Flush key pad has warning red light flashing entered engineers code plus 99 exit but panel is dead apart from green on and red flashing
John
April 2017
Flush key pad has warning red light flashing entered engineers code plus 99 exit but panel is dead apart from green on and red flashing
John
April 2017
Thanks very much Nick - it has gone back to day mode. However, the green 'power' light is still on and it usually is off.
Does this mean there is a problem with the power supply and it is working from the battery?
Thanks again
Dean
February 2010
Im only guessing as im not in your home, But at a guess, if you only have the green mains light on, id say your in engineering mode. Key in 9 9 enter and the panel should go back to day mode.
Tel 07842 480037 Kent Based engineer with 25 years experience
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.