The tab that holds the slide plate broke the other day and to replace it you have to remove the bobbin holder and the gear on the bottom. We thought we put it all back the same way but the needle won't pick up the bobbin thread and doesn't make a stitch. Tried adjusting the gear and just get a jam with the thread. Are there timing marks or a procedure to reset everything to before?
Hello Dwight,
Bit confused about the slide plate bit ! if you email me I will attach timing instructions, type my address as you say it and not as you see it.
ken
drivewithken at blueyonder dot co dot uk
January 2010
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
