I wish to know the position of the timing pin hole on the camshaft. All diagrams show it (using the clockface system) as about 5, the hole that I have found in that position has somthing in it, another hole at about 10 is a threaded hole but that does not line up. is it posible a previuos attempt at timing has resulted in the hole being blocked. If that is the case what can be done.
Thanks K. I think you mean the flywheel timing hole thanks anyway
Les
January 2010
hole is between lower part of starter and engine block in backplate ,and looking towards rear of engine is about 25 past,hole is usually bare but may have a build-up of rust in it!
k
January 2010
Hi Nigel. I do have the sealey kit instructions, my main concern is if the timing hole is blocked and is THAT hole the timing hole. Thanks anyway
Les
January 2010
Hi Les, would you like a copy of the set up info ?
nige110162(at symbol)hotmail.co.uk
nigel
January 2010
Thanks Paul. The vehicle is a Citroen Dispatch, Y reg not sure about the origin of the engine
Les
January 2010
If you tell us the make/model & year of the vehicle this is fitted in you would stand a better chance of getting help
howtomendit.com for free repair help, information and advice.
