I have an Image 10.2Qi treadmill (model IMTL1199). The belt stopped about 2 years ago and it was deptermined that the it needed a new motor control board which I replaced, It operated fine until about 2 weeks ago and the belt has stopped again. I have tested the motor and it is OK. Before I spend the money on another motor control board, is there a way to test to see if the circuit breaker is the problem?
Yes - set breaker switch to on - check for power on the input side and then check for power on the output side.
Otherwise - if the machine shows any sign of electrical life with the breaker on - then the breaker is good.
On the control board the weak link is likely to be the motor drive transistor - probably a triac on a heat sink - costing just a few £$ - you might consider replacing it on spec before spending loads-a-money on a new control board - this last paragraph is all guesswork - I do not own any exercise equipment and have never repaired any.
Good luck...
Peccavi
January 2010
Automatic Answer
We may have found other answers which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix gym/fitness equipment.