how can i fix report code SC36-05 on a Konica Minolta?

To reset a fuser abnormality code, perform the following:
1. Access the 25 mode (hold down the 2 and 5 keys at power up) or turn the main switch ON and
wait for the Ready to Copy message. Hold the P button down until the message Enter 4-digit
P*ssword To Change is displayed.
Note: The button must be held down for about 5 seconds before the message is displayed.
2. Enter the p*ssword 9272 and press the Start Print button.
3. Press [1: Software SW setting] on the touchscreen.
4. Press the left up-arrow, which is displayed on the touchscreen, 2 times. The number displayed
above the up-arrow will change to 03.
5. Select the bit number of switch 1, using the right up-arrow, 03-1 will be displayed.
6. Press the [OFF (0)] key, which is displayed on the touchscreen.
7. Power the machine OFF/ON to exit the 25 mode or press RETURN, MODE CHANGE and then
BASIC SCREEN to return to normal operation.

if the error continues replace the thermistors in the fuser

jd miller
November 2010