Digistat/glow worm?

my programmes are fine, but either it heats up too much or does not start at all. In other words i think that the problem is with the thermometer (or thermostat). If the displaying numbers are the curent temprature, than it is displaying wrong temprature. To correct this problem i have to set the programe at high tempratures. My programmed tempraures for night time from 1030pm) = 22C, 1 (9:30am) = 0C to stop the heating, 2 (6:00pm) 17C and 3 (8:00pm)= 19C. Now only night tempraure works because they are the highest one. But again it is too hot. Is there a way that i could correct the sensor which tells what exactly is the temprature? Any solution?

sarwar
October 2009

Thankyou But I am well aware how to set the timing on it, but the point is if all four stages are set to 7 degrees it should not call for heat untill the temperature drops below this. but it does, as i asked, why. regards robbie

robbie
September 2009

Because it is a THERMOSTAT, which changes the Set Temperature at diffrent times of day.

Go and sit down with the installation and user guide for your digistat and digest the contents, then have a go a programming it propely
i.e.
7-00 20'c 9-00 15'c 16-00 21'c 22-00 5'c
(Or whatever suits you)
some models also allow a diffrent schedule for each day of the week as well

www.elanar.co.uk
September 2009