Hi I stripped my ferm table saw down to build a better 1 out of wood and I lost my pictures with the order the wires fit into the start stop switch can anyone help it's for the ferm 1700w table saw and I need to know we're the overload relay goes if any1 has the saw could look at theirs to help Me please much apriciated
ross
April 2015
nothing happens when I switch it on any ideas please it is a fzt 250
kel
March 2014
i need a motor for a ferm bensh sor bv 105739/2001
gary
November 2013
I just bought one of your bench saws, theres 3 booklets that tell you everything apart from how to put it together ?
m. shaw
October 2013
George, If you can't get hold of a manual... I have a copy of the FZT-250 User Manual. To be fair, it is not very informative, but I could get the English pages and exploded views copied to PDF files and email to you, if that's any help. 01159858330 (I believe we can't put e-mail addresses on this site)
Chas D
December 2010
please can anyone help I am looking for the instruction manual for a fern fzt 250n bench saw,
serial no 107337/2002
Hi, have broken the cast angle guide on my FZT-250 was wondering if anybody out their had a spare for sale.
Ernie D
June 2010
I have just sheared the gearbox on my saw. Has anyone out there got one with a dead motor? I am in the middle of cutting bed slats for a new spare bed and this has scuppered me!
Ian K
January 2010
I have one which is in good working order, but the guide rail is broken. I'm prepared to let you have it. Cambs
john conti
September 2009
This place sells ferm parts
http://www.servotool.eu/index.php?p=category_list&cat=POWER&prod=SAND BELT
dan
August 2009
Hi Dave Dee,
They will not let me put my e-mail address on this site, 01299823266.
Thanks Dennis Brown.
Dennis Brown.
August 2009
Hi Dave Dee,
I have asked Mend It how i can pass on my e-mail address to you, Will let you know.
Thanks Dennis Brown.
Dennis Brown
August 2009
Hi Dennis, Just logged in again to this sight so sorry for the delay. I do not want anything for the part you want, just pay the postage. The only problem is how do we get in contact with each other without putting details on this open sight? You may have more experiance on such matters than me.
dave dee
August 2009
Hi Dave Dee,
I have a Ferm Table saw FZT-250, The alloy casting on the end of the motor that the blade bolts to has broken. Would you consider selling it to me.
Thanks Dennis Brown.
Dennis Brown.
August 2009
do not know the answer to your question in June, but I have just burnt the motor out on mine. I'ts not worth the cost of a new motor even if I could find one, but if any bits of my machine are any good to you please let me know.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix sanders.