my dyson dc05 will not start, i have checked fuse, how can i mend?

The wire at the plug end can break but not very noticable.....I cut off plug and fitted a new one!

Andy
April 2009

possible metal fatigue in the cable somewhere. Mine was just below where the cable enters the moulded plug. Wiggled it and it would come on. Solution: chopped off 4 inches below the moulded plug and fitted new spare 13amp 240v plug. Clamped the cable inside the plug a little tighter than normal to compensate for 'pulling' at full stretch when in use. Good luck!

mt_9
October 2008

Hi, Just go to www.dyson-online.com and check out their technical advice section. The site is fantastic! Good luck.

Charles
January 2006

Check the under carriage between the wheels, you should see a blue & red wire. Ensure that the blue wire is connected to the clear plastic, like wise with the red cable. My blue cable had come lose over time. I just had to reconnect the male to female connectors.

billyeve
December 2004

more that likely to be a broken wire in the lead

RS
October 2004