Why has Dyson DC04 lost suction and cleaning brushes stopped rotating?

If you have a DC24 like mine and you find the brush has stopped rotating because it got clogged [symptoms are that it doesn't vacuum the floor properly, even though the suction works on the attachment], try taking off the brush roll holder and cleaning it. See: youtube.com/watch?v=ghvP8X0TMMs

That's what I did and it worked fine. No spares to buy, nothing broken.

John B
April 2011

If it is a DC04 with brush control, the most probable cause is that the brush drive belt or the clutch guide wheel it runs on has been damaged by running the motor while the brush bar was jammed. If this is the case, it will require that the clutch assembly with the belts needs replacing.

Austin
May 2009

On the right side of the Vacuum on the beater brush cover you will see a small button and beside that you should see a tinny hole. This hole is a reset button, take a small pin and insert it into the hole. Does your brush turn now?

Trainer
April 2009

Turn the hoover over and take the part off around the brushes and check to see if the rubber band has either come away or broken. If not check the pipes not clogged with hair and dust at the side.

Jonathan
April 2009

Not an expert, but sounds like a belt has broke that drives the roller the brushs are on. Must be a cover to come off to see. Good luck!

Terry B
April 2009

Check out dysonmedic.com

Nice pictures and how to do text

Peccavi
April 2009