Or remove only the outer screws from the back plate, leaving the drum still attached. Pull back panel and drum and fit belt from the front.
Guinness
February 2009
remove all the screws from the back panel,then carefully pull the back out until there is a gap for the belt to go between back panel and drum.fit the belt around drum (will be tight),then tip dryer on its side and remove plate on base (4 screws).find belt and pull it as hard as you can over the motor pulley ( very hard ).reassemble and try.
ck
February 2009
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
