Dyson DC04 dead?

move the flexible hose out and note a small hole that goes into the on/off switch. Put a screwdriver through the hole to push the plastic back and the on/off buttton can be lifted off. Then remove the phillips screw that holds the switch assembly to the cleaner. The power lead and switch can then be pulled out.

bryan
May 2009

Thanks for the tips, I found a broken mains lead just inside the body.....saved £200!!! yes!!.....thanks again....Kev.

Kev.
September 2004

Have a look in a few of the other questions relating to the DC04. I have just had to repair my cable which had broken down inside, just as it enters the casing. There is some good advice regarding removing the switch housings.

DCT
September 2004