I have a TMC model PHT 35 hedge trimmer. The engine is a Kawasaki KT 12 AD. It won't start and I need to know how to set the carburetor mixture screws to the original factory settings. There are two screws, a large and a smaller one. I think the large screw is high speed mix and the smaller screw is the idle mixture. This same engine is used on Flymo mowers and there is a perfect picture of the mixture screws on You Tube. Any help would be appreciated.
Hi, are you sure its not the points at fault? these live underneath the fly wheel & if you have a slightly leaky crank seal it will have covered the points in a fine oil mist or they could just need setting up , same happened to mine, new seals & a good clean up & runs like new, Rob...
rob
September 2008
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix lawn mowers.